Troubleshooting the ZenoTOF 7600 System: In-Run Calibration Failures


日期: 12/15/2022
类别: QTOF Systems

1 投票数
   打印    评价文章:

For research use only. Not for use in diagnostic procedures.


Answer

If a calibration failure occurs while acquiring data on the ZenoTOF 7600 system, then certain measures can be followed to mitigate this issue. The troubleshooting guide accessible here provides a step-by-step approach for resolving issues with in-run calibrations, starting with opening the calibration report in the Analytics workspace of SCIEX OS software to identify the reasons behind the failure.

There are two other ways to obtain a calibration report in the event of an in-run failure: 1) Clicking on the red X in the Queue workspace in SCIEX OS software, and 2) Locating the appropriate file from the Data/Cal folder in the project of interest.